Rena OEM Fountain/Circulating Pump 70gph/25 in lift, 6' cord ETL or UL Listed, 3yr warranty

Question

Q: Is this pump submersible? I am trying to replace pump that appears to be an older Rena pump. The photo on the label says that it is 66gph Type S 10a. Will this work as a replacement? Thank you Nik

Asked by: Nik - 1/4/2016

Q: Hi, I have a Rena C-20 60 GPH pump thats missing the little part that sits on top of the red rotor. Is there any way I can get this part? Thank you! Liliane Miller Charlotte, NC

Asked by: Liliane - 3/15/2018

Q: I have a JR-350 Submersible pump. This pump is similar to the one I have? The pump connects to the tube inside my fountain head. The 2 tube attachment you provide, both fit into the receptacle and the reason for the two is depending on my fountain opening? Thank you

Asked by: Stuart - 5/28/2019

Q: I have a tabletop fountain that uses a renas20 pump. The pump still works but the two parts that bring water in and out broke and the tubing doesn’t make a water tight fit. Is this likely the right replacement?

Asked by: Margaret - 8/14/2021

Q: Trying to replace Rena Flow 300 in a small fountain. Your suggestion is appreciated

Asked by: Bob - 5/18/2024

Questions about this item? Ask here.

Accepted Answer

Yes it is submersible. This is your best choice because the pump has a very low profile but still comes with a 3/8 outlet adapter which is the most common tubing used with the old S10. This pump is not as tall but with the addition of the 3/8 adapter is very close. Every fountain or other piece of equipment where S10's are used will usually work with the RO320S as well. We accept returns up to 30 days after purchase and we do have other pumps that we sometimes use depending on the installation.

Accepted Answer

A: Your best bet is to call us. What you might be looking for is the impeller cover or possibly the small rubber bearing or bushing. Not sure by your description. We might have both.

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: Administrator (4/23/2018)

Accepted Answer

A: You should have 3 adapters. One mounted on the pump and two for other tubing sizes. If you have to remove the one adapter (1/2") it will come out but you may need pliers to remove it since the fit is very tight.

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: Administrator (5/28/2019)

Accepted Answer

You have what is called an "in-line" pump which can be used both submersed or out of the water. It is a closed loop system. No pumps we make today will work. If this is a Virginia Metalcrafters fountain or something similar you'll need to modify the fountain to work with a basin underneath holding the water and a pump. Can be done but the unit will no longer set on a pedestal.

Accepted Answer

The RO320S is the closest thing we have to the old RF300. Any version of the RO320 works fine unless your old pump was installed with a tube attached to the intake. Only 1% of the pumps sold used this configuration and we have no replacement for that model (RO300S-IL) inline pump.

Rena OEM Fountain/Circulating Pump 70gph/25 in lift, 6' cord ETL or UL Listed, 3yr warranty

Related Items

Recently Viewed Items